Fun with Two Heddles

 

  • image from www.flickr.com
  • image from www.flickr.com
  • image from www.flickr.com
  • image from www.flickr.com
image from www.flickr.com

I've been having a great time using two 10 dent heddles with my new double heddle kit I bought for my Emilia. I've never had to think so hard about threading. It was a brain teaser, but once done (by studying my Jane Patrick book, numerous websites and blogs, and also discussions on Ravelry), it all makes sense. Really! Basically, it's pulling four ends through each of the back heddle (also known as heddle II). Wind on your warp. Pull one strand from each grouping into each eye. So, when heddle II is warped, it has three ends in the slots, one end in an eye.

Then, you add in the front heddle (also known as heddle I) and it gets a little muddy, but in a nutshell, you pull two slot ends into a slot, the third slot end into an eye, and the final fourth end, which had been in the eye of heddle II, into the slot on the far side of the eye you just sleyed. Okay… make sense? Good! Continue on down, warping all of heddle I. 

Now, you're ready! See? It's easy!

Well, not really. Would you believe it took me three hours? To warp 8" across? And just 36" long? Yes? Then you'd be wrong, because it actually took three and a half hours. Now, the next time, it'll be a cinch. 

Once all that warp was carefully tied on, I was ready to weave… something… didn't know what… So, I pulled out Jane Patrick's book, picked a pattern from the Double Heddle chapter, and started weaving. I chose the Diamond pattern, mostly because it uses two heddles and no pickup sticks. (Yes, you can add in pickup sticks!) And there was much head scratching and pulling out of weft and so on as I followed the eight steps to complete one pattern section, until I finally realized it made sense and I was weaving the diamond pattern.

I'm using a variety of browns, reds, and off-whites from my embroidery thread collection. It's pretty, and even though my brain was taxed, it was worth it.

Leave a Reply

Your email address will not be published. Required fields are marked *